Aquacraft Nitro Hammer Manuel d'utilisateur télécharger pdf

Warranty

• AquaCraft

™

will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft will

either repair or replace, at no charge, the incorrectly made part.

• Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase

and we must see it before we can honor the warranty.

• To return your Nitro Hammer

™

for repairs covered under warranty you should send your boat to:

Hobby Services

1610 Interstate Drive

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F

E-mail: hobbyser[email protected]

ASSEMBLY AND OPERATION MANUAL

™

Before Building:

We want the assembly and operation of this boat to be a success so BEFORE removing any parts from the parts bags please

read this manual thoroughly and watch the included video to familiarize yourself with the model. If for any reason you

think this model is not for you, return it to your local dealer immediately. PLEASE NOTE: Your hobby dealer cannot accept

a return on any model after assembly has begun.

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Before Building:

Warranty• AquaCraft™will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft willeither repair or repl

Page 2

INTRODUCTION ...2SAFETY PRECAUTIONS...2H

Page 3

Do not use too much force when tightening self-tappingscrews into plastic or fiberglass. Over tightening will causethe threads in t

Page 4 - RUNNING THE ENGINE

❏ 2. Remove the body clip that holds the lid to the radio boxand carefully remove the cover.❏ 3. Carefully uncoil the receiver antenna and rou

Page 5 - BREAKING IN THE ENGINE

❏ 3. Open the high-speed needle valve 2-1/2 turns out(counterclockwise) from fully closed. The high-speed needle issticking up on the left si

Page 6

2. Do not over-lean your engine.3. Do not run your engine without a propeller.4. Do not over heat the engine. This goes along with keepingit clean and

Page 7 - PERFORMANCE TRICKS AND TWEAKS

equipment to get wet, you must do the followingimmediately: Remove the battery pack and radio equipmentfrom the boat. Allow the components to

Page 8 - ENGINE TROUBLESHOOTING

• For “drag racing” place the buoys similar to the above sketch.•For “oval racing” place the buoys similar to the abovesketch. NOTE: The above